KIDD Threaded Receiver Pins — secure your trigger group and eliminate loose pins for good.
What makes it special
·Prevents trigger guard pins from falling out when removing the barreled action
·Designed specifically for KIDD .22LR receivers but can be fitted to most 10/22®-style receivers
·Threaded screws lock the trigger group in place for a stable, service-ready setup
·Clean, flush fit when used with an 82° countersink on non-KIDD receivers
Key specs
·Includes two threaded receiver pins,four screws, and needed short arm wrenches
·Material: precision-machined steel hardware
·Designed for KIDD receivers; compatible with standard 10/22® receivers with proper countersinking
·Retains trigger assembly during maintenance or stock changes
Avoiding lost pins — our engineering
Traditional 10/22® cross pins can slide out easily during disassembly, often sending the trigger group to the floor. KIDD’s threaded receiver pin system eliminates that problem entirely. The threaded screws clamp to each side of the receiver, keeping the trigger assembly secure even when the barreled action is out of the stock. When upgrading a non-KIDD receiver, a simple 82° countersink ensures the screws sit flush and clean.
Installation & break-in tips
·KIDD receivers come ready for these pins
·For non-KIDD receivers, countersink each pin hole to 82° so screws seat flush
·With screw on one end insert each pin through the aligned trigger and receiver holes
·Install the second screw on each pin using the included hex wrenches
·Tighten finger tight only—do not apply excess torque
·Verify smooth trigger unit alignment after installation
