Upgrade your Ruger® 10/22® with a fluted, blued chromoly bull barrel that looks showroom-sharp and shoots match-grade tight.What makes it special Style + substance: Fluted profile gives your 10/22® a high-end appearance while retaining the mass of a .920" bull contour for stable harmonics and repeatable aim. Match-grade components: Bored & rifled by Lothar Walther (Germany), finished and hand-machined by Tony Kidd, and chambered with a proprietary reamer for smooth feeding. Extraction reliability: Precision convex extractor slot keeps the extractor perfectly aligned with the case rim — a tight-tolerance feature that prevents common extraction problems. Finish & threading: Black bead-blasted chromoly with a durable blued finish and 1/2"-28 muzzle threading (protective cap included) for suppressors or muzzle devices. Guaranteed accuracy: ½" at 50 yards (5-shot group) — proven performance you can trust. Key specs• Fit: Slip-fit for factory Ruger® 10/22® and most aftermarket 10/22® receivers • Length: 18" • External diameter: .920" bull contour (fluted) • Material: Chromoly steel, black bead-blasted, blued finish • Twist: 1:16 (optimized for .22 LR) • Crown: 11° crown + double ring at muzzle; KIDD marked • Extractor slot: Convex design for consistent extraction • Muzzle threading: 1/2"-28 (protective cap included) • Performance guarantee: ½" at 50 yards (5-shot group)Barrel weight• 18" fluted chromoly — 3.0 lbFitment & avoiding barrel droopBarrel droop is caused by an insecure or inconsistent tenon/shoulder fit. We eliminate droop with: A precise fit between tenon and receiver, with a consistent diameter along the tenon length. A precisely machined shoulder with a relief cut to allow the shoulder to seat flush against the receiver providing full support. When properly fitted, v-block screws only need to be snug (~10 in-lb) — tight enough to prevent forward movement without distorting alignment.Installation tips If using another brand of receiver clean paint/build-up from the receiver mortise before installing. Apply a light coat of grease to the tenon to ease installation—use sparingly. Begin inserting the tenon while aligning the extractor slot. Tap the rear of the receiver with your palm; if resistance increases, use a rubber mallet to fully seat. Recheck extractor alignment by matching the level of the receiver’s bottom flat with the barrel’s v-block cutout. Run two magazines through the barrel before evaluating groups, and repeat when changing ammunition brands. Keep the chamber clean but avoid over-cleaning the bore—excessive cleaning can reduce accuracy. Typical bore cleaning interval~ every 500 rounds, depending on ammo Upgrade your 10/22®Upgrade your 10/22® with a barrel that pairs show-quality styling with match-grade function — proven components, precision machining, muzzle threading for accessories, and a performance guarantee you can trust.
